EverydayFix.
Everyday Skills

How to Tie a Four-in-Hand Knot

Make a slim, slightly asymmetrical knot with a standard necktie.

Across → behind → across

Then bring the wide end up through the neck loop and down through the front band.

A hand adjusts the slim navy tie knot at the collar of a white shirt
Generated editorial illustration of a tied necktie.
Wrap
Across, behind, across
Thread
Up through the neck loop
Finish
Down through the front band

Step by step

  1. Start with the wide end lower

    Raise your collar and drape the tie around your neck. Put the wide end on your right and give it more length than the narrow end.

  2. Wrap around the narrow end

    Cross the wide end left over the narrow end, pass it back underneath to the right, and cross it over the front again. Keep a finger under the new front band to hold it open.

  3. Thread and tighten

    Bring the wide end up through the neck loop from underneath. Feed it down through the front band, then pull gently while holding the knot.

  4. Set the length

    Hold the narrow end and slide the knot toward your collar. Aim for the wide tip to reach the middle of your belt buckle. If it sits too high or low, undo it and adjust the starting length.

Official instructions and references · Tie-a-Tie