How to Find a Wall Stud
Use a stud finder to locate both edges of a stud.
Confirm its location before drilling. A stud reading alone does not rule out a wire or pipe.

Step by step
Calibrate on the wall
Use the detector’s instructions and select the setting for the wall material. Scan across slowly and mark where the reading starts and ends.
Repeat at a different height
A stud should produce a consistent position on multiple passes. Measure nearby stud locations as a cross-check, and treat typical spacing as a clue.
Assess what is behind the wall
Take extra care near outlets, plumbing fixtures and utilities. If you cannot verify a safe drilling location, use a qualified installer.
Official instructions and references · Zircon stud finder support